Examiner les modifications individuelles

'<br>The 4 inch cam lock is one of the more popular and widely used control valves. They are primarily used to control the amount of water in a pool, because of their small size. If you have any sort of questions relating to where and how you can make use of [https://www.shunchengvalve.com/spring-check-valves/ www.shunchengvalve.com], you can contact us at the web site. They are also commonly found in automatic control systems, such as sprinklers and other irrigation devices. There are many different makes and models of these valves available, but a very popular brand among swimmers is the Nissen waterless cam lock.<br><br><br>A cam lock is designed with two balls (one ball fits into the top part of the valve and the other ball fits in the bottom part). When the valve is closed the inside ball traps the outside ball. When the water reaches the top of the valve, the inside ball releases the water and the outside ball allows it to drain back into the pool. On the other hand, when the water is flowing toward the bottom of the valve, the exterior ball traps the inside ball. In order for the system to be properly shut off, there needs to be a constant balance between the two balls.<br><br><br>The cam lock is one of the easiest valves to install in your pool. It comes with an instructional manual that guides you through the process step-by-step. One important thing to remember when installing the cam lock is that the two valves must be installed on opposite sides of the pool. If they are installed on the same side, the water will cause imbalance in the system.<br><br><br>Some people are intimidated at first because they do not fully understand how the valve works. However, after they have read the manual, they can understand how to adjust the valves. Once they have adjusted the control ball, they can start using it and see exactly how it works. Then they can understand why the cam lock needs to be adjusted so that it can work properly.<br><br><br>Adjusting the cam lock is very easy to do. First of all, find the control ball. To find the control ball, place the cylinder lever next to the seat. The lever needs to be pulled back slightly. This will allow water to travel up the seat tube and then to cover the ball.<br><br><br>Next, place the control ball on the floor next to the seat. Turn the valve handle up until water starts spraying from the ball. It is very important that you watch the water coming from the control ball to ensure that the spray makes it go where you want it to go. Adjust the ball until the water stops spraying.<br><br><br>Now, close the valve. It is important to remember to shut the valve completely before shutting off the water supply. If you forget to close the valve, the water will run down the pipe and you could have a leak. If you close the valve partially, the water will escape and the valve won't close fully, which will allow the water to go up into the house. To check if the valve is closed completely, open the control valve all the way and check the pressure in the system.<br><br><br>Installing a cam lock can take about two hours. Be sure to read all the instructions and then follow them carefully. You should know how to get to the lock, turn on the power and run a test to make sure there are no leaks. It is also important to make sure that all screws are tightened evenly. You will need to have someone help you to do this. It is not difficult to install a cam lock, but it does take some effort.<br>'